Hitachi 55HDS52 Manuel d'utilisateur télécharger pdf (Page 10)

 POWER light indicator

To turn the monitor ON, press the main power

switch located on the lower right side of the

monitor. A red stand-by indicator lamp located on

the lower right corner of the front bezel will

illuminate. The Plasma TV is now ready for remote

ON/OFF operation.

 REMOTE CONTROL sensor

Point your remote at this area when selecting

channels, adjusting volume, etc.

 LEARNING AV NET sensor

Point your equipment’s remote control at this area

while using the AV NET Learning Wizard.

 SIDE INPUT JACKS (for VIDEO: 5)

Use these audio/video jacks for a quick hook-up

from a camcorder or VCR to instantly view your

favorite show or new recording. Press the INPUTS

button then use the CURSOR PAD and the SELECT

button on the remote control to select INPUT 5. If

you have mono sound, insert the audio cable into

the left audio jack.

Front/Rear/Side Panel Controls

First time use

Indicating Lamp Power Status Operating

Off Off When the main power switch is set to

OFF.

Lights Red Off When the main power switch on the display

(Stand-by) monitor is ON.

Lights Green On Display monitor MAIN POWER is ON.

Lights Orange Off Display monitor MAIN POWER is ON

(Power Saving) with no signal input except antenna

(no sync. signal).

NOTES: 1. Your HITACHI Plasma TV will appear to be turned OFF (lights orange) if there is no video input

when VIDEO: 1, 2, 3, 4 and 5. Check the Power Light to make sure the Display Monitor is

turned off or in Stand-by mode (lights red) when not in use.

2. Remote Control can not turn ON/OFF the “MAIN POWER” of the display monitor.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 87 88

Pas de commentaire

Hitachi 55HDS52 Manuel d'utilisateur Page 10