Hitachi VM-E520A Manuel d'utilisateur télécharger pdf (Page 16)

Getting Started - 16 -

2. Lift the battery holder plates at the center of the attachment holder.

3. Insert six alkaline batteries with the correct polarities.

4. After installing the batteries, close the cover. Hold the OPEN lever and align the tabs on both sides of the cover

with the end of the attachment section.

Note: Use only "AA" alkaline batteries marked "LR6". (Manganese batteries cannot be used to power the

camcorder.)

Note: It is recommended that you use alkaline batteries within the recommended period of use or within two

years of the date of manufacture.

Note: Be careful of the following to prevent the leakage of liquid or an explosion.

• Check that the orientation (polarity) of the batteries is correct.

• Remove the batteries when not using the camcorder.

• Remove the used batteries from the camcorder.

• Do not use batteries made by different manufacturers at the same time.

• Do not use old and new batteries at the same time.

Note: If the liquid leaks, remove the batteries immediately and ask your nearest dealer to inspect the

camcorder (this will be at your own expense).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 49 50

Pas de commentaire

Hitachi VM-E520A Manuel d'utilisateur Page 16