Hitachi CP-X2021WN Manuel d'utilisateur télécharger pdf (Page 24)

Operating

Adjusting the projector's elevator

When the place to put the projector is slightly uneven to the left or right, use the

elevator feet to place the projector horizontally.

Using the feet can also tilt the projector in order to project at

a suitable angle to the screen, elevating the front side of the

projector within

12 degrees.

This projector has 2 elevator feet and 2 elevator knobs. An elevator foot is

adjustable while pulling up the elevator knob on the same side as it.

Holding the projector, pull the elevator knobs up to loose the elevator feet.

Position the front side of the projector to the desired height.

Release the elevator knobs in order to lock the elevator feet.

To loose an elevator foot,

pull up the elevator knob

on the same side as it.

To ﬁnely adjust, twist the foot.

After making sure that the elevator feet are locked, put the projector down

gently.

If necessary, the elevator feet can be manually twisted to make more precise

adjustments. Hold the projector when twisting the feet.

►Do not handle the elevator buttons without holding the

projector, since the projector may drop down.

►Do not tilt the projector other than elevating its front within 12 degrees using

the adjuster feet. A tilt of the projector exceeding the restriction could cause

malfunction or shortening the lifetime of consumables, or the projector itself.

CAUTION

Use the ZOOM ring to adjust the screen size.

Use the FOCUS ring to focus the picture.

Adjusting the zoom and focus

12°

FOCUS ring

ZOOM ring

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 106 107

Pas de commentaire

Hitachi CP-X2021WN Manuel d'utilisateur Page 24